Vacuum Wood Grain Machine For Wooden Door 3500mm*1500m Working table

Product Application

The equipment is used to transfer the wood grain to wooden doors.

Wood effect machine Working Process

First put the door on the platform, the surface dust blowing clean, and then sprayed with special plastic glue to ensure that the front door, the side

are even cloth rubber, if you need to do stripes effect, you can do in the stripes where the laying of cutting Good transfer film.After the glue dry

,put the door on the plastic machine platform, covered with grain transfer film, adjust machine temperature to 120-140 degrees, the blister

pressure transferred to 0.7-0.8Mpa for plastic. The Secondary spray glue and plastic, repeat the first process .

2.Product Pictures

3.Product transfer effect

4.Advantages

4.1. Perfect decoration effect:

Wood effect decoration is good, clear patterns,strong adhesion,without decoration leakage on deep slot,corner turns

4.2. Low cost and high efficiency

Compared to original manual transfer printing method,this new type transfer printing machine has two working tables (alternative working),1~2

workers enough to finish the whole working process. It takes 5~8 mins to finish wood effect decoration process,open the working table,remove the

transfer film,no any additional working process.

4.3. Durable

1).The vacuum suction use special PVC plastic films,good adsorption,heat resistance and long life time

2). Electric control system adopts domestic and foreign well-known brands which is safe and reliable.Ensure the transfer printing machine running

safely and effectively,reduce frequency and cost of maintenance.

4.4. Easy operation

It is very easy to operate this machine,no need more technical training.

5.Our Service

6.Packing & Delivery